• Custom manufactured to fit specific width and length of potato bed

End Caps

• Manufactured from 14 Gauge steel which is then primed and painted
• Specially designed end caps prevent potatoes from sitting on the top edge of the bed wall
• End caps measure 20 inches in height allowing you to cover your heaped load

Tension Control System

• Extension springs along with beveled pulleys on both ends of the tarp apply constant and uniform pressure to keep your tarp rolling evenly
• A specially designed locking flange is used to lock the roll tube in the closed position

Sidewall Structure

• The specially designed sidewall structure acts as an extension assisting the end caps in providing room for heaped loads without the use of cross-members. This enables the harvest boom to be lowered into the bed to minimize the drop height of the potatoes, thus reducing bruising.

Electrical System

• A 12 volt electric motor, supported on a pivot arm is used to rotate the roll tube to open and close your tarp.
• The pivot arm is attached to the motor and to the bottom ledge of the potato bed

Tarp Fabric

• Fabric is a 19 oz. PVC available in 16 colors: plum, black, red, white, yellow, It. gray, forest green, orange, It. green, burgundy, charcoal, brown, electric purple, navy, It. blue, royal blue.
• Reinforced edges on front, rear and sides
• Heat welded seams

Options

• Insulated tarp material R-2
• Hinging Rear hood to allow conveyor access
• Manual/Hand Crank style
• Spring loaded cross-members